- 您现在的位置：买卖IC网 > Sheet目录515 > SIR323-5 (Everlight Electronics Co Ltd)LED IR 5MM WATER CLEAR RADIAL
DATASHEET
5mm Infrared LED
SIR323-5
Although the recommended soldering conditions are specified in the above table, dip or hand soldering at the lowest
possible temperature is desirable for the LEDs.
?
Wave soldering parameter must be set and maintain according to recommended temperature and dwell time in the solder
wave.
4.
Cleaning
?
?
When necessary, cleaning should occur only with isopropyl alcohol at room temperature for a duration of no more than
one minute. Dry at room temperature before use.
Do not clean the LEDs by the ultrasonic. When it is absolutely necessary, the influence of ultrasonic cleaning on the LEDs
depends on factors such as ultrasonic power and the assembled condition. Ultrasonic cleaning shall be pre-qualified to
ensure this will not cause damage to the LED
5.
Heat Management
?
?
Heat management of LEDs must be taken into consideration during the design stage of LED application. The current
should be de-rated appropriately by referring to the de-rating curve found in each product specification.
The temperature surrounding the LED in the application should be controlled. Please refer to the data sheet de-rating
curve.
6.
ESD (Electrostatic Discharge)
?
?
?
?
Electrostatic discharge (ESD) or surge current (EOS) can damage LEDs.
An ESD wrist strap, ESD shoe strap or antistatic gloves must be worn whenever handling LEDs.
All devices, equipment and machinery must be properly grounded.
Use ion blower to neutralize the static charge which might have built up on surface of the LEDs plastic lens as a result of
friction between LEDs during storage and handing.
7.
Other
?
?
?
Above specification may be changed without notice. EVERLIGHT will reserve authority on material change for above
specification.
When using this product, please observe the absolute maximum ratings and the instructions for using outlined in these
specification sheets. EVERLIGHT assumes no responsibility for any damage resulting from use of the product which does
not comply
with the absolute maximum ratings and the instructions included in these specification sheets.
These specification sheets include materials protected under copyright of EVERLIGHT corporation. Please don’t
reproduce or cause anyone to reproduce them without EVERLIGHT’s consent.
8
: (3)
Revision Copyright ?
No: Release Date:
2010, Everlight All Rights Reserved. Release Date : JUN.12.2013. Issue DIR-0000993
www.everlight.com
LifecyclePhase:
Expired Period: Forever
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
SIR333-A
LED IR 5MM WATER CLEAR RADIAL
SIR383C
LED IR 5MM BLUE WATER CLEAR AXL
SIR383
LED IR 5MM BLUE WATER CLEAR AXL
SIR404DP-T1-GE3
MOSFET N-CH D-S 20V 8-SOIC
SIR406DP-T1-GE3
MOSFET N-CH D-S 25V PPAK 8SOIC
SIR414DP-T1-GE3
MOSFET N-CH D-S 40V 8-SOIC
SIR418DP-T1-GE3
MOSFET N-CH D-S 40V PPAK 8SOIC
SIR436DP-T1-GE3
MOSFET N-CH D-S 25V PPAK 8SOIC
相关代理商/技术参数
SIR330DP
制造商:VISHAY 制造商全称:Vishay Siliconix 功能描述:N-Channel 30 V (D-S) MOSFET
SIR330DP-T1-GE3
功能描述:MOSFET 30 Volts 35 Amps 27.7 Watts RoHS:否 制造商:STMicroelectronics 晶体管极性:N-Channel 汲极/源极击穿电压:650 V 闸/源击穿电压:25 V 漏极连续电流:130 A 电阻汲极/源极 RDS（导通）:0.014 Ohms 配置:Single 最大工作温度: 安装风格:Through Hole 封装 / 箱体:Max247 封装:Tube
SIR333/H19/F51-R11 S7440
制造商:Everlight Electronics Co 功能描述:
SIR333-A
功能描述:LED IR 5MM WATER CLEAR RADIAL RoHS:是 类别:光电元件 >> 红外发射极 系列:- 标准包装:1,200 系列:- 电流 - DC 正向(If):100mA 辐射强度(le)最小值@正向电流:27mW/sr @ 100mA 波长:940nm 正向电压:1.6V 视角:40° 方向:顶视图 安装类型:通孔 封装/外壳:径向 包装:带卷 (TR)
SIR333-A_05
制造商:EVERLIGHT 制造商全称:Everlight Electronics Co., Ltd 功能描述:5mm Infrared LED, T-1 3/4
SIR333C
制造商:Everlight Electronics Co 功能描述:LED INFRARED - Bulk
SIR333C/H0/L9
制造商:EVERLIGHT 制造商全称:Everlight Electronics Co., Ltd 功能描述:5mm Infrared LED, T-1 3/4
SIR333C-H0
制造商:EVERLIGHT 制造商全称:Everlight Electronics Co., Ltd 功能描述:5mm Infrared LED, T-1 3/4